2.2. Start the update
1. Connect the USB memory to the HEOS Player's USB Port.
2. Updating is started automatically.
3. Player's status LED should be blinking amber during upgrading the rmware.
Example of HEOS 5 LED Actions.
LED on the front is blinking amber.
4. One the upgrade is complete, the player reboots automatically.
Example of HEOS 5 LED Actions.
LED on the front is blinking blue.
5. Ready-Congured and connected to your network.
Example of HEOS 5 LED Actions.
6. Be sure to rewrite the service region setting.
See "3. Service region settings update procedures".
--- Precautions for Updates ---
• Never remove the USB memory before the update is nished.
• Never turn off the power before an update is completed.
Once an update is started, normal operations cannot be performed until it is completed.
• When update is complete, the folder name on the USB ash drive changes to "
heos_40.prod.update.done
".
To use the les again,
delete the
".
done
" part.
18
To Next Page
Loading...
