Denon PMA-1520AE - Connecting a playback device

17
Appendix
TipsSettingsPlayback
Contents
Front panel Rear panel IndexRemote
Connections
Connecting a playback device
You can connect turntables, tuners, CD players and network audio players to this unit.
This unit is compatible with turntables equipped with a moving magnet (MM) phono cartridge. When you connect to a turntable with a low output moving
coil (MC) cartridge, use a commercially available MC head amp or a step-up transformer.
If you set this unit’s input source to “PHONO” and you accidentally increase the volume without having a turntable connected, you may hear a hum noise
from the speakers.
AC IN
GND
AUDIO
OUT
R
L
AUDIO
OUT
AUDIO
OUT
AUDIO
OUT
AUDIO
OUT
LR
LR LR LR
R
L
R
L
R
L
R
L
R
L
R
L
R
L
R
L
BD player Turntable CD player
Network
player
Tuner
%
•The PHONO input terminals are equipped with a short pin-plug.
Remove this plug to connect a record player.
Store the removed short pin-plug in a safe place so as not to
lose it.
NOTE
•The ground line (SIGNAL GND) on this unit is not a safety
ground. Connect it to reduce noise when noise is excessive.
Note that depending on the turntable, connecting the ground line
may have the reverse eect of increasing noise. In this case, it is
not necessary to connect the ground line.