Denon PMA-1520AE - Setting the power amp direct mode

27
Appendix
TipsPlaybackConnections
Contents
Front panel Rear panel IndexRemote
Settings
When a pre-amplifier is connected to this unit and the unit is used as a
power amplifier, follow the instructions below to turn power amp direct
mode on.
POWER AMP DIRECT
Turning power amp direct mode on
1
Press POWER AMP DIRECT on the main unit.
•By switching this on, it is possible to play back a device connected
to the Power Amp Direct connector on the rear panel. In this case,
the input indicator is turned o.
Turning power amp direct mode o
1
Press POWER AMP DIRECT on the main unit.
•By switching it o, it is possible to play back the program source
selected using the INPUT SELECTOR knob. In this case, the input
indicator lights up.
NOTE
•When the power amp direct mode is on, adjustment of the volume, balance and
tone on the main unit has no eect. Adjust the volume on the pre-amplifier.
•When the power amp direct mode is on, the main unit outputs at maximum
volume. Check the output level on the input device before playing it and adjust the
volume accordingly.
Setting the power amp direct mode