Connect the turntable’s ground wire here
is terminal
is used to reduce noiso when a
xtable, etc., is connected.
lees not provide grounding.
----- ----
_-. -....- -I
1
This switch is set according to the type of player cartridge
to be used.
Set this switch
IO
MM (.@I,) or MC (-1 according to the
type of cartridge used or1 your iurntable.
* Speaker impedance
0 When using speaker systems A and 6 separately, speakers
with an impedance of 4. ‘to 16 S.&hms can be connected.
@ When biwiring wilh biwireable speaker system, speakers
with an irnpeclance of 4 to 16 Q/ohms can be connected.
0 Note that when [ising two sets of speaker systems together
(A t- B), use speakers wth iinpedance 8 to 16 S./ohms,
using speakers with an impedance other than I)etween 8 to
‘I6 ~/Oht’nS
may cause damageS.
Note that this unil is not equipped with a switch for
selecting the speaker sysiem. The A and 13 speaker output
terminals are connected in parallel.
0 The proteciive circuit tnay be activated if speakers with
other impedances are conr~ected.
* Be sure to connect the cords between the speaker terminals
and speaker systems with the same polarities (@ to CD, 8 to
0). If
not,
the central sound will bo weak and Che position of
the dif-Ferent instruments witI not be clear, diminishing the
stereo effect.
~3 When connecting the speakers, he sure that the core wires of
the speaker cords do not slick out from the terminals and
touch olher terminals, each other or the rear panel.
0 Connecting the speaker cords
@ Peel off the sheathing from the end of the cord.
@ ‘Twist the core wires.
0 Turn the speaker terminal counterclockwise to loosen it.
@I Insert ,the core wires entirely, then turn the terminal
clockwise ‘10 lighlen il.
This set is equipped with a high speed protective circuit.
This circuit protects the internal circuitry from damage due
to large currents flowing when the speaker jacks are not
completely connected or when an output is generated by a
shot-t circuit. This protective circuit’s operation cuts off the
output to the speakers. In such a case, be sure to turn the
power off and check the connections to the speakers.
Then turn the power
on
again. After muting for several
seconds, the set will operate normally.
- -_._
-I
NEVER touch the speaker terminals when the power is on.
1 Doing so could result in electric shocks.
To Next Page
Loading...
