* Make sure that all the connections are proper by referring to
the rear panel.
a Check the polarity (positive and negative) of connections,
and tile directivity of stereo separation (right cord io right
channel terminal, r-nd IeFt cord to loft channel terminal).
0 Check the directiviry of pin cord connection.
* Turn the volume control lknob counterclockwise, I.0
minimum position.
* Sat the rotary knot
@ Set SOlJRCE DIRE
Aflcr checking the above items, turn on the power, the alnplifier
is se1 in l.lie ready mode in a few seconds.
~~~~
A
B
1. Set the CARTRIDGE selection switch “MC LEE)” or “MM
1”.
2. the INPUT SELECTOH switch to “PMONO”.
3. Operate the turntable and play the
4. ‘lilrn the volume and tone conlrols to yield an
appropriate vol~~me and sound quality.
1 Set LIE INPUT SELLECIOR switch to “CD”.
2. Operale the CD player.
3. Turn i:he volume @ and tono controls
appropriate volume and
sound
qua!ity.
to yield an
‘I. Sel the INPUT SELECTOR switch
2. Operate the tune
3. Turn the volume @ and tone controls
appropriate volume and sound quality.
to yield an
P L !AY I N
CI
1
~~~~~~
‘I. Set .the INPUT SELECTOR switcii 0 1.0 “OVD/AUX-‘I ” (UIJX-2/
I-? DIRECT) position.
2. Operate the Audio equipment
SySiW7S.
3. Turn the volurne @ and tono conitols
to yield an
appropriate volun~e and sound quality.
If power amp direct svi/itch (BACI< PANEL) is set to ON
position, powor amp direcl terminal is selecied when AUX-.
2/S? DIRECT is selected. (see
.~ --_____--.- -.- . ..-
1. Set ,the INPIJ’I’ SELECTOR switcl\ @ to “TAPE.--l/CD-R” OI
“TAPE.2/MD”.
2. Opetate the iape Ueck.
3. Turn the volume @ and tone controls
, @,
I.0 yield an
appropriate volume and :xx~ixf quality.
1. Set ,the HEC OIJT SELECITOR switch to ihe program
source you wish to record.
2. Play back ihe program source.
3. Start recording with the component connec-ied to “TAPE-
l/CD-R” or “TAPE-2/MD”.
0 In the PMA-ZOOOIVR, the REC OUT signal and the speaker
(headphona) signal are output via separate circuits so that
knobs and switches related to the tone and volume have no
effect whal ever 011 ,the sound that is recorded. Also, since the
recording Function is selected by the REC OUT SELECTOR
the free program source can be played through the
or headphones) even during recording.
A recording in progress can be monitored if a .Lape deck with
three individual heads -for recording and playback is used. A
tape deck iI\ which a common head is used for both recording
and playback cannot be used to monitor recording. When a
Irecording is being made using ‘TAPE-l/CD-R, selecting rAPE-
I/CD-R with the INPUT SELECTOR will engage the
FIECORDtNG MONITOR and pemil a check of the recording
condition.
SELECTOR switch
---.-.-.-
, set the REC OUT
1
Copying is not possible from .TAPEG/MD to TAPE-I/CD-R.
0 ‘This amplifier has a full memory back- system. When the
power is lurned on, INPUT SELECTOR
ale set to the last
mode set before the power was turned off.
To Next Page
Loading...
