Denon PMA-425R - Remote Control Operation

REMOTE CONTROL OPERATION
The accessory Remote Control Unit is used to contro! the amplifier from a convenient distance.
{1} Inserting the Dry Cell Batteries Notes on Battery Usage
1. Remove the battery cover on the Remote Control Unit. e@ RC-176 uses the size R6P (AA) dry cell batteries.
®@ The batteries will need to be replaced approximately once a
= year. This will depend upon how often the Remote Control
Unit is used.
r @ If, in fess than a year.from the time new batteries were
inserted, the Remote Control Unit fails to operate the Amplifier
from @ near-by position, it is time to replace the batteries.
e insert the batteries property, following the polarity diagram
inside the battery compartment.
@ Batteries are prone to damage and leakage. Therefore:
Do not mix new batteries with used ones.
« Do not mix different types of batteries.
© Do not jumper opposite potes of the batteries, expose them
to heat, break them open, nor expose them to apen fire.
@ (fthe batteries have lesked, remove any traces of battery fluid
from the battery compartment wiping thoroughly with a dry
cloth. Then insert new batteries.
2. Insert two dry cell batteries as shown in the diagram on
the battery supply unit.
3. Replace the battery cover.
==, £
(2) Directions for use
© Operate the Remote Control Unit while painting it towards the
Remote Control Sensor on the Amplifier as shown in the
diagram on the left.
@ The Remote Control Unit can be used at distances up to about
8 meters in a straight line from the amplifier. This distance will
decrease if there are obstructions blocking the Infra-red light
transmission or if the Remote Controi Unit is not directed
straight at the amplifier.
Note on operation
*@ Do not press the operating buttons on the Amplifier and the Remote Control Unit at the same time. This will cause misoperation.
@ Operation of the Remote Control Unit will become less effective or erratic if the infrared Remote Control Sensor on the Amplifier is
exposed to strong light or if thera ave obstructions between the Remote Control Unit and the sensor.
@ Incase you operate a VCR, TV or other components by remote control, do not operate buttons on two different remote contro! units at
the same time: This will cause misoperation.
Besides being able to operate the PMA-525R/425R amplifier with this Remote Control Unit, you can also operate
a DENON cassette deck and CD player from this handy full-system Remote Control Unit.
Remote control section
Fult-system Remote Control Unit
The fult-system Remote Control Unit operates ali major functions of the Amplifier, such as function switching, volume control. But that's
not alll The same control pad can also control the major functions of a DENON CD player and cassette deck and tuner when combined with
the PMA-525R/425R to create a remarkably ergonomic and versatile DENON system with all the quality sound reproduction that the
devoted audiophile expects.
12
Remote Control Unit RC-176 supplied with the PMA-525R/425R
o button
This button can be used to turn on and off the power of the
amplifier.
However, the power for the amplifier turned on and off if it
is in the power standby mode and the power cord is
plugged in.
This button will not function if there is a power
failure, if the power cord is not plugged in, or when
using an audio timer.
@ = MUTING button
Pressing this switch will activate the muting condition and
Tape Fae Aux. no signals will be output to the speakers.
(ale
TuMin co promo Other buttons
HC} Ct) Other buttons are exctusively for the PMA-525R/425R, and
function in the same way as the corresponding buttons on
the set. ¢
REMOTE CONTROL UNIT RC-176
PLAY button
@ PLAY (REV} | PLAY (REV) button
STOP button
REWIND button
Refer to the operating
instructions of your
Mt PAUSE OENON tape deck.
A/B DECK
Are SELECT button
> PLAY PLAY button
@ STOP STOP button
Reverse
Track
PRESET
¢
buttons
La Search button Press this button to move up or down among the preset
Forward Track station numbers.
sad Search button
RANDOM
REPEAT instructions
of your DENON
OISC SKIP CO player
W PAUSE PAUSE button
*@ The RC-176 Remote Control Unit can control CD players and cassette decks manufactured by DENON.
e@ Note that operation may not be possible for some models.
@ Buttons are conveniently separated into groups, each group controlling one specific component. The groups ara AMP, FUNCTION, CD,
DECK and TUNER etc..
For details on operating ather components, refer to the operating instructions for the CD player and/or cassette deck.
CAUTION:
if the power is turned off with the Ramote Control Unit, the set is switched to the power stand-by state. If you are ‘absent for a
long period of time, unplug the power cord.
Onty the MUTE/STANDBY LED @ tights when In the power stand-by mode.
You may experience erratic operation of the Remote Control Unit if it is operated in fluorescent light and direct sunlight, in
particular if this tight strikes the Remote Control Sensor on the Amplifier. However, this is not a malfunction, and if this should
happen, simply protect the sensor against such light.