FIRMWARE UPDATE PROCEDURE
1. Procedure for upgrading IC214
1.1. Items to Be Prepared
(1) Personal Computer (Be installed "Flash_Loader_Demonstrator_v2.6.0_Setup.exe").
(2) RS-232C cable (9P (Male), Straight).
(3) 8U-210100S Writing Kit(SPK-581 WRITING KIT). 7P FFC(Straight).
1.2. Connecting the WRITING KIT to This Unit
(1) Disconnect the AC plug of this unit to turn the power off.
(2) Connect the RS-232C cable from PC with the WRITING KIT.
(3) Connect the WRITING KIT to the update terminal of this unit.
MAIN PCB
PC
WRITING KIT
RS-232C Cable
7P FFC
Insert the FFC to match
the mark of 1st Pin.
The Left side is the 1st pin.
26
To Next Page
Loading...
