Denon PMA-50 - Rear Panel; Power and speaker connections; Digital and analog audio inputs; Subwoofer terminal

n
Audio section
• Output performance
Rated output:
both channels driven
25 W+25 W (8 Ω/ohms, 1 kHz, T.H.D. 0.1 %)
50 W+50 W (4 Ω/ohms, 1 kHz, T.H.D. 1.0 %)
Output connectors:
Speaker: 4-16 Ω/ohms
Headphones:
Φ6.3 mm jack
Total harmonic distortion:
0.004 % (Digital in, Rated output -3 dB, 8 Ω/ohms, 1 kHz)
S/N ratio:
110 dB (Digital in, 25 W, 8 Ω/ohms, 1 kHz, IHF-A)
• Digital input signal
Audio formats:
Digital audio interface (Linear PCM)
Coaxial input:
0.5 Vp-p/50 Ω/ohms
Optical input:
More than ? 27 dBm
Wavelength:
660 nm
• Input performance
Input sensitivity / Input impedance:
AUX: 0.13 V / 22 kΩ/kohms
n
Bluetooth section
Communication system:
Bluetooth version 3.0
Transmission power:
Maximum 2.5 mW (Class2)
Maximum communication range:
Approx. 32.8 ft/10 m in line of sight *
Frequency band:
2.4 GHz band
Modulation method:
FHSS (Frequency-Hopping Spread Spectrum)
Supported profiles:
A2DP 1.3/AVRCP 1.5
Supported codecs:
aptX Low Latency/AAC/SBC
*The actual communication range varies depending on the inuence of such factors as obstructions between devices, electromagnetic waves from
microwave ovens, static electricity, cordless phones, reception sensitivity, antenna performance, operating system, application software etc.
n
General
Power supply:
E3 AC120 V, 60 Hz
E2 AC230 V, 50/60 Hz
Power consumption:
35 W
Power consumption in standby mode:
0.2 W
For purposes of improvement, specications and design are subject to change without notice.
TECHNICAL SPECIFICATIONS
9