0
Getting Started Connections Operation Troubleshooting
ENGLISH
n
Power amplier section
Rated Output Power: 2-channel driving (CD → SP OUT)
50 W + 50 W (8 Ω/ohms, 20 Hz ~ 20 kHz, T.H.D. 0.07 %)
Dynamic power: 85 W + 85 W (4 Ω/ohms, DIN, 1 kHz, T.H.D. 0.7 %)
High frequency distortion: 0.01 % (Rated output: –3 dB), 8 Ω/ohms, 1 kHz
Output terminals: Speaker A or B: 4 ~ 16 Ω/ohms
A + B: 8 ~ 16 Ω/ohms
Suited for headphones/stereo headphones
n
Pre amplier section
Equalizer amplier output: 150 mV
(REC OUT terminals)
Input Sensitivity/Input Impedance: PHONO (MM): 2.5 mV/47 kΩ/kohms
CD, TUNER, LINE, RECORDER-1, RECORDER-2:
105 mV/47 kΩ/kohms (SOURCE DIRECT OFF)
105 mV/13 kΩ/kohms (SOURCE DIRECT ON)
RIAA Deviation: PHONO (MM): 20 Hz ~ 20 kHz ±0.5 dB
n
Overall performance
SN Ratio (A network): PHONO (MM): 86 dB
(With input terminals short-circuited, 5 mV input signal)
CD, TUNER, LINE, RECORDER-1, RECORDER-2:
107 dB (input terminals short-circuited)
Tone control (bass): BASS: 100 Hz ±8 dB
TREBLE: 10 kHz ±8 dB
LOUDNESS: 100 Hz: +6 dB, 10 kHz: +6 dB
n
General
Power supply: AC 230 V, 50 Hz
Power consumption: 200 W
0.3 W (Standby)
Power outlets: 3 switched outlets, total capacity 100W (0.43A)
Maximum external dimensions: 434 (W) x 121 (H) x 307 (D) mm
Weight: 6.7 kg
n
Remote control unit (RC-1131)
Batteries: R03/AAA Type (two batteries)
Maximum external dimensions: 49 (W) x 220 (H) x 21 (D) mm
Weight: 120 g (including batteries)
z: For purposes of improvement, specications and design are subject to change without notice.
Specications
Specications
Index
A
Adjust the tone ......................................................8
Adjust the volume .................................................8
B
BALANCE ..............................................................3
BASS .....................................................................3
Batteries ................................................................2
Bi-wiring Connection .............................................6
C
Cables Used for Connections ...............................5
Connecting Players ...............................................6
Connecting Recorders ..........................................7
Connecting the Speakers ......................................5
Copying Recorders ................................................8
I
INPUT SELECTOR .................................................8
L
LOUDNESS ............................................................3
P
Power cord ............................................................7
Protection circuit ...................................................5
S
SOURCE DIRECT...................................................3
Speaker cables ......................................................5
SPEAKERS A/B ......................................................3
Stereo pin-plug cable ............................................5
T
TREBLE .................................................................3
V
VOLUME ................................................................3