Denon PMA-725R - Remote Control Operation

REMOTE CONTROL OPERATION
The accessory Remote Control Unit 1s used to control the amplifier from a convenient distance.
(1) Inserting the Dry Celt Batteries Notes on Battery Usage
1, Remove the battery cover on the Remote Control Unit. @ RC-176 uses the size REP (AA) dry cell batteries.
®@ The batteries will need to be replaced approximately once a year.
This will depend upon how often the Remote Control Unit is used.
© If, inJess than a year from the time new batteries were inserted, the
Remote Control Unit fails to operate the Amplifier from a near-by
Position, it is time to replace the batteries.
© Insert the batteries properly, following the polarity diagram inside
the battery compartment.
@ Batteries are prone to damage and leakage. Therefore:
@ Do not mix new batteries with used ones.
2. Insert two dry cell batteries as shown in the diagram on the bat- @ Do not mix different types of batteries
tery supply unit ®@ Co not jumper opposite poles of the batteries, expose then to
heat, break them open, nor expose them to open fire.
© Ifthe batteries have leaked, remove any traces of battery flurd from
the battery compartment wiping thoroughly with a dry cloth. Then
insert new batteries
(2) Directions for use ® Operate the Remote Control Unit while pointing it towards the Re-
mote Control Sensor on the Amplifier as shown in the diagram on
the left.
© The Remote Controi Unit can be used at distances up to about 8 me-
ters in a straight line from the amplifier. This distance will decrease
if there are obstructions blocking the infra-red light transmission or
if the Remote Control Unit is not directed straight at the amplifier
Note on operation
© Oo not press the operating buttons on the Amptifier and the Remote Control Unit at the same time. This will cause misoperation,
© Operation of the Remote Control Unit will become less effective or erratic if the infrared Remote Control Sensor on the Amplifier is exposed to
strong light or if there are obstructions between the Remote Controi Unit and the sensor.
@ Incase you operate a VCA, TV or other components by remote conto!, do not operate buttons on two different remote control units at the same
time. This wilt cause misoperation.
Besides
being
able
to
operate
the
PMA-925R/725R
amplifier
with
this
Remote
Control
Unit,
you
can
also
operate
a
DENON
cassette
deck
and
CD
player
from
this
handy
full~system
Remote
Control
Unit.
Remote control section
Full-system Remote Control Unit
The
full-system
Ramote
Contro!
Unit
operates
atl
major
functions
of
the
Amplifier,
such
as
function
switching,
volume
control.
But
that’s
not
all!
The
same
controt
pad
can
also
contro!
the
major
functions
of
a
DENON
CD
player
and
cassette
deck
and
tuner
when
combined
with
the
PMA-925R
/725R
to
create
a
remarkably
ergonomic
and
versatiie
DENON
system
with
all
the
quality
sound
reproduction
that
the
devoted
audiophile
expects.
+
12
Remote Control Unit RC-176 supplied with the PMA-925R/725R
© (POWER) sutton
This button can be used to turn on and off the power of the ampli-
fier.
However, the power for the amplifier turned on and off if itis in
the power standby mode and the power cord is plugged in
Bic get cy har This button will not function if there is a power failure, if
CoO mal a the power cord is not plugged in, or when using an aud.o
KEW FED PLAY timer,
@ = MUTING button
ee Lol
SI It - ¥ Pressing this switch will activate the muting condition and no
Seca Signals will be output to the speakers.
Tare JaPEy aux
Other buttons
Other buttons are exclusively for the PMA-925R/725R. and
function in the same way as the corresponding buttons on the
set.
£0 POND
DENON
REMONE CONTRO, UNIT ACITE
» PLAY PLAY button
<q PLAY (REY) PLAY (REV) button
@ stop STOP button
dq REW REWIND button
FF >> FF button
Reter to the operating
instructions of your
it PAUSE DENON tape deck
&/B W-DECK A/B DECK
SELECT burton
D> PLAY PLAY button
@ STOP STOP button
Revere ieee PRESET ¢ buttons
ere
ue
Press
this
button
to
move
up
or
down
among
the
preset
Forward Track Station numbers.
Search button
Refer to the
operating
instructions
‘of your DENON
CO player
PAUSE button
RANDON
DISC SKIP
WW PAUSE
®
The
RC-176
Remote
Control
Unit
can
control
CD
players
and
cassette
decks
manufactured
by
DENON
Note
that operation
may
not be
possible
for
some
modeis
*
Buttons
are
conveniently
separated
into
groups,
each
group
Controlling
one
specific
component.
The
groups
are
AMP,
FUNCTION,
CD
,
DECK
and
TUNER
etc
«
For
details
on
operating
other
components.
refer
to
the
operating
instructions
for
the
CD
player
and/or
cassette
deck
CAUTION:
@
If
the
power
is
turned
off
with
the
Remote
Controt
Unit,
the
set
is
switched
to
the
power
stand-by
state.
tf
you
are
absent
for
a
long
period
of
time,
unpiug
the
power
cord.
© Only the MUTE/STANDBY LED @ lights when in the power stand-by mode.
@
You
may
experience
erratic
operation
of
the
Remote
Control
Unit
if
it
is
operated
in
fluorescent
light
and
diract
suniight,
in
particular
if
this
light
strikes
the
Remote
Control
Sensor
on
the
Amplifier.
However,
this
is
nota
malfunction,
and
if
this
should
happen,
simply
protect
the
sensor
against
such
light.
13
a PO I I Fe el es wuseZ/Uuseec-vWd