Denon S-52 - Fj Network Setting

II Network Setting
Make settings for wired or wireless LAN.
Wired LAN
Make settings for wired LAN.
hen the network
rvers.
(
Tum on the S-52's power.
)
+1
If a Ethemet cable is connected
I
The mode automatically switches to "Wired'~
To acquire the IP address automatically
I
To enter the IP address manually
I
using the DHCP function
+
At the menu "SETUP" - "Network Setting"
- "Network Setting" - "Detail" setting, set
"DHCP" to "Off" and enter the
IP Address,
Subnet Mask, Gateway, Primary
DNS and
Secondary DNS.
To not pass through the. proxy server
I
To connect via proxy server
I
This setting is required w
, r is established via proxy se
At the menu "SETUP"
-"Network Setting" -
"Network Setting"- "Detail" - "Proxy" setting,
set "Proxy" to "On" and enter the address or
domain name and port numbers.
,r
"
I
This completes the setting.
I
#' Recheck the connections and settings if you cannot connect to the Internet (eif'page 9).
cmm Knowledge about networks is required to make the IP Address and Proxy settings. For details, consult a network administrator.
12