ENGLISH
Advanced
Operation
Alarm Setting
Set the alarm time, source
and
volume.
1Press
<ALARM
SETTING>
to set the alarm.
2
[Alarm number selection]
Thrn
<Multi
Jog>
to select "ALARMl" or
"ALARM2", then press
ENTER.
The
time display flashes.
3
[Alarm time setting]
Select time with
<Multi
Jog>,
then press
ENTER
to
set.
*
Turn
<Multi
Jog>
clockwise to increment the set value, and counter-
clockwise to decrement
it.
4
[Alarm source setting]
Select alarm source with
<Multi
Jog>,
then press
ENTER
to
set.
5
[Alarm volume level setting]
Select alarm volume level with
<Multi
Jog>,
and
press
ENTER
to
set.
6
Press
<ALARM1>
or
<ALARM2>,
and set the alarm
on.
• When the input source
is
CD,
iPod
or
PC
Music, if music does not
play when the alarm
on
time IS reached, a Beep will sound.
• Alarms 1
and
2 operate separately.
• If the set
is
not operated for
60
minutes after alarm playback starts,
playback stops and the power turns off
(The
Beep sound stops after
5 minutes).
• When you want alarm playback of
an
iPod
recording, set
iPod
while
pausing the track you want to
play.
o Pausing alarm playback (snooze function)
Press
<MUTE
/
SNOOZE>
during alarm playback.
Alarm playback resumes 5 minutes after it was stopped.
o Stopping alarm playback
Either press
<ALARM1>
or
<ALARM2>
on
the main unit to turn the
alarm off, or press the main unit's
<FUNCTION
ON/OFF>.
If there
is
a power failure
o When connected
to
a network
When the power comes
back
on,
the set automatically connects
to
an
SNTP
(Simple Network Time Protocol) server and the current
time
is
adjusted automatically. Once the zone, daylight saving time
and
alarm time
have
been set, they
are
stored
in
the memory,
so
there
is
no need to set them again.
o When unconnected to a network
When the power comes
back
on,
the clock resumes from the time
the power turned off. If the time
is
way off, turn the power
on
and
reset the current time. If the alarm time
has
been set, it
is
stored
in
the memory, so there
is
no need to set it again.
Setting the SleepTimer
Use
thiS
function to automatically sWitch the power to the
standby mode after a specific amount of time (minutes)
1Set the current time (n2lf'page 11).
2During playback, use
SLEEP
to
select the time.
r
120
---90 --- 60 ---
50
--- 40 --- 30 ---
20
---10
~
- Off
_.
-------'
"*
After about 5 seconds, the previous display reappears and the
timer starts.
3
The power is set
to
the function off mode after the set
amount
of
time.
Canceling the sleep timer
Press
SLEEP,
select "Off" from the sleep timer time display.
Checking the
time
remaining until
the
sleep timer
starts
Press
SLEEP.
Checking the current time
Press
[DISPLAY]
or hold down
DIMMER
for 2 seconds or more.
The
time
is
displayed.
27
To Next Page
Loading...
