Denon UDR-F10 User Manual

00
[2] BEFORE RECORDING AND
PLAYING TAPES
Cautions on handling cassette tapes
@C-120 cassette tapes
C-120 (120-minute) cassettes use very thin tape which can
easily get caught on the capstans and pinch rollers. We
recommend not using C-120 tapes.
@ Tape slack
tf the tape is slack, it may get caught in the mechanism
and damaged. Take up any slack in the tape with a pencil,
etc., before loading the cassette.
@ Preventing accidental erasure
© Cassette tapes have tabs for preventing accidental era-
sure. Use @ screwdriver, etc., to break off the tabs to
prevent recordings from being accidentally erased.
*@ To record on a tape whose tabs have been broken. place a
piece of cellophane tape, etc., over the tab holes
Accidental erasure protection
tab for side A
Accidental erasure protection tab for side 8
WNotes on storing cassette tapes
@ Avoid placing cassette tapes in the following types of
places:
@ Hot or humid places
@ Dusty places
e Places exposed to direct sunlight
@ Near magnetic sources (TVs, speakers, etc.)
@ Store cassette tapes in cases with stoppers to prevent the
tape from getting slack
The D-F10 is equipped with an auto tape selector mechan-
ism which uses the detection holes in the cassette halves to
detect the type of tape and automatically set the most
appropriate recording bias and equalization for that type of
tape.
@ Do not use ferrichrome tapes.
e@ When an old metal tape with no detection holes is used,
the treble will be stressed excessively, so use meta! tapes
with detection holes.
16
Accidental erasure pvotection tabs Detection holes
Metal tape
Chrome tape
NOTE:
© Load cassette tapes with the side on which the tape is
exposed facing the set. Loading them the other way
may result in damage.
@ Loading
@ Press the OPEN/CLOSE button. The cassette tray
opens.
@ Load the cassette tape in the cassette tray as shown
on the diagram below, with the side on which the
tape is exposed facing inside.
@ Press the OPEN/CLOSE button to close the cassette
tray.
@ Unloading
@® Press the OPEN/CLOSE button. The cassette tray
opens.
@ Remove the tape.
Check the following before recording or playing cassette tapes:
1. Are the heads diny?
-The sound quality will be poor if the heads are dirty.
Refer to Page 25.
2. Are the accidental erasure protection tabs broken off? ...... Recording is not possible if the accidental erasure protection
tabs on the top of the cassette are broken off. Refer to Page 16.
0)
m
2
m
a
>
-
7)
m
QO
=
2)
2
LS SL SA a IST a I TEST () | —1- ]

Denon UDR-F10 Specifications

General

Brand	Denon
Model	UDR-F10
Category	Stereo System
Language	English