Denon UDRA-90 - Page 15

Example 3: Unattended recording of radio broadcasts (“air checks”)
[1] EVERYDAY TIMER
POWER
ONSTANDBY.
—» Press the deck
OPEN/CLOSE button
to open the tray.
yy;
© &
DOWN UP
AUTO _TUNING
GLU
ENTER
Press the receiver's POWER
button to switch on the
power.
— Load the cassette tape to —* Press the OPEN/CLOSE
which you wil record. button again to close the tray.
Press the receiver's
TIMER button.
Press the UP button
to display “EVERY”.
TIMER
Press the ENTER/NEXT button.
/ NEXT
Press the UP and DOWN buttons
of the receiver to display
DOWN ONY
” AIR CHECK ”. AUTO _ TUNING
6 Foliow steps 6 to 18 under “Setting the Timer” on Page 12.
AIR CHECK
[2] ONCE TIMER
POWER
ONSTANDBY
Cky
Press the receiver's POWER
button to switch on the
power.
OPEN /CLOSE
»
Tete
os
QQ
9
T=
—»
Load
thecassettetapeto
—*
Press
the
OPEN/CLOSE
which
you
will
record.
button
again
to
close
the
tray.
—> Press the deck 2
OPEN/CLOSE button
to open the tray.
Press the receiver's
TIMER button.
TIMER
TIMER
2)
Press the DOWN button ae UP
to display “ONCE”.
TIMER
Press the ENTER/NEXT button.
Press
the
UP
and
DOWN
buttons
/
of
the
receiver
to
display
A
I
R
CH
E
CK
” AIR CHECK ".
Follow steps 6 to 18 under “Setting the Timer” on Page 13.
e Timer recording starts in the direction indicated by the tape deck.
@
Check
that
the
tape
direction
and
REV
MODE
switch
settings
are
as
desired.
@
The
section
of
leader
tape
at
the
beginning
of
the
tape
cannot
be
recorded.
To
avoid
missing
the
beginning
of
the
recording,
forward
the
tape
about
10
seconds.
Checking the Timer Settings
To
check
the
timer
settings,
turn
on
the
receiver’s
POWER
button,
press
the
TIMER
button,
select
“EVERY”
or
“ONCE”
with
the
AUTO
TUNING
UP
button,
then
press
the
ENTER/NEXT
button.
The
timer
start
mode,
reception
band,
preset
number,
on
time,
and
off
time
are
displayed
in
order
each
time
the
ENTER/NEXT
button
is
pressed.
One
more
press
returns
the
display
to
the reception
frequency.
Changing the Timer Settings
When
the
timer
setting
operation
is
repeated,
the
previous
settings
are
deleted
and
the
new
settings
are
set.
Deleting the Timer Settings
The timer settings can be cleared by pressing the TIMER button, select “EVERY” or “ONCE” with the AUTO TUNING UP
button, then press the ENTER/NEXT button and then while “ FUNC ” is being displayed, pressing the CLEAR button.
Note about the Set Timer
If the set time of the timer is reached while the power is on, the timer settings will take over and there will be a switch to the
function that has been set on the timer.
ancelling the Timer
Press the STANDBY button and the “ © ” mark will go off.
15