Denon UDRA-90 - 10 RECORDING CASSETTE TAPES; Recording from Various Sources

PC ENGLION
RECORDING CASSETTE TAPES
1R
By 29008
225
Press the OPEN/CLOSE button &
and load the tape to which you
will record.
Refer to Page 17.
Set the REV MODE switch to =" or [D.
Refer to Page 16.
Set the DOLBY NR switch.
Refer to Page 6 @.
Gu
Press the BAND selector} Press the receiver's
button.
4
Select the station
you wish to record.
(Refer to Page 9.)
Press the REC MUTE button.
OPEN /CLOSE
: y
Single-side recording Two-side (reverse) recording.
REV MODE
ceo)
Oy)
Set to B or C to record
with Dolby NR.
DOLBY NR
B OFF C
cay
(7
FUNCTION button and
select AUX.
Start playback on the DAT. Set the disc
in the CD player.
{Refer to
Page 18.)
REC MUTE
The REC | (5)
(recording)
& indicator
lights.
CID SRS
Gy
Press the ® or @ button.
{Recording starts)
Press the CD
SRS button.
{recording starts.)
mss
7 | To stop recording, press the stop button.
When the CD SRS but-
ton is pressed, a 7-
second blank portion is
automatically created
before recording starts.
[1] PLAYING CDs
e Press the OPEN/CLOSE button (4) once to open the disc try, once again to close it.
e The disc tray can also be closed by pressing the play (>) button.
When
this
is
done,
playback
automatically
starts
from
the
first
track
on
the
disc
(or
if
the
tracks
are
programmed,
the
first
programmed track).
e Load the disc with the label side facing up, being careful not to touch the disc surface.
e Load the disc with the disc tray open all the way.
@ Set the disc securely in the tray guide at the center of the disc tray.
To play an 8 cm disc, place the disc in the sunken part at the center of the disc tray.
@ When the disc tray is closed, the disc turns automatically for several seconds, and the number of tracks and total playing
time appear on the display.
Only discs with this mark can be
played.
@When removing the disc from its case:
As shown in the diagram, grasp
the disc along the edges, gently
press down on the hole in the
middle with a finger, and lift the “+
disc. It should come out easily. A o y
™ When setting the disc in the disc tray:
Atways set the disc with the
label side facing up. (Compact
discs can only be played on one
side). For 8 cm CDs, set the disc
in the sunken part in the middle
of the tray.
DIGITAL AUDIO
e For CDVs, only the audio part is played (the video part is
not played).
Only the audio part is
played.
CD single
(8 cm)
Handling the Disc Tray
Do not switch off the power or push or pull the disc tray when it is moving,
since this may damage it.
If the cord of a set of headphones, etc., gets caught in the disc tray when it is
closed, press the OPEN/CLOSE button { &) again.
e Never set objects other than CDs in the disc tray, as this can cause damage.
NOTE:
“NO DISC” is displayed on the display window when no disc is
loaded, when the disc is loaded upside-down, or when the disc is not
properly loaded. Also,” § 0.06, ™ may appear during playback
of a CD if the disc is scratched or dirty. If this happens, the set will not
operate when a normal operating button (other than the OPEN/
CLOSE button) is pressed, so press the OPEN/CLOSE ( & ) button,
remove the disc, clean it as necessary, then press the PLAY ( > )
button again.
IS oO*oo"