Denon UDRA-90 - 4 CONNECTIONS; System Interconnection

[4] CONNECTIONS
FM antenna
AM loop antenna
Power plug
AC 230 V 50 Hz,
AC 240 V 50 Hz (for U.K. model}
{Plug into a power outlet.}
<4
CAUTION
Plug the included AC power cord securely into the inlet
socket in the receiver.
1 Power cord
\ (for U.K. model)
the antennas.
Keep the FM and AM antenna wires away from the
system connector wires to prevent noise from entering
Digital output jack
(OPTICAL)
e Digital data is output in op-
tical form from this jack.
eContact your nearest
DENON Consumer Center
or office for information on
the optical fiber cable to be
used for connection.
=a uu
© Connecting the System Connector Cord |
RECEIVER When connecting the system connector cord, press on the center of the
connector plug until you hear a click.
¢ When disconnecting the system connector cord, press the sides of the
i] connector plug towards the middle and puil.
i ir i {
Connector plug
I
Connector
cord
| CD PLAYER
u Note that disconnecting by pulling on the cord can damage it.
y i
Record Player (Option) |
| © Do not plug the power cord into the outlet until all connections have
been completed. Connect properly as illustrated in the diagram.
| : e Check the left and right channels, then properly connect the left
connector 5 * Sit i i
} cord oud CASSETTE speaker's terminals to the amplifier's L terminals and the right
“418-pin} (13-piay” DECK speaker's terminals to the amplifier’'s R terminats.
i @ Insert the plugs securely. Incomplete connections can cause noise.
@ When the power cord has been disconnected from the power outlet,
wait about 5 seconds before plugging it back in.
OUTPUT INPUT
AUDIO
(MM cartridge) e Note that grouping connection cords together with power cords or
setting them near power transformers can cause hum or other noise.
© Note that if the input jacks selected with the FUNCTION button are
open {if a component is not connected), there might be leakage of the
reproduced sound of a component connected to another set of input
jacks,
NOTE:
This system includes digital circuitry which may inter-
fere with the colors on a TV. Should this occur, switch
off the power of the unused componentt(s).
USC-30
{Left channel} (Right channel)
The sets can also be placed next to one another.
y
a
5
Se
<>
SXS
ead
ee
oe
:
ee
x
See
SMS
OK
Speaker system connections
Connect the speaker system for the
left channel (the left side as seen from
the front) to the L terminals, and the
speaker system for the right channel
to the R terminals.
st
KR
ae
:
220
(CD PLAYER}
(RECEIVER)
(CASSETTE DECK}
CAUTION:
System operation is not possible and the power cannot be turned on and off unless all system
connector cords, speaker cords and pin-piug cords are connected.