Denon UDRW-250 - Auto On;Off Functionality; System Auto Power Management

[is] SPECIFICATIONS
© Tuner-preamplifier (UTP-250)
fi3]
AUTO
ON/OFF
FUNCTION
e
When
the
CD
or
deck
play
button,
or
the
OPEN/CLOSE
button
is
pressed
from
the
standby
mode,
the
power
is
switched
on
auromaticelly,
and
the
play
or
open/close
operation
is
performed.
The
“AUTO
OFF”
indicator
lights
st
this
time.
@
When
play
ends
in
this
mode
and
there
are
no
operations
for
10
minutes,
the
power
is
automaticatly
switched
off
and
the
system
enters
the
standby
mode.
if
there
is
no
disc
or
cassette
in
the
system,
the
power
will
be
switched
off
in
about
1
minute.
When
the
disc
tray
or
the
cassette
tray
is
open,
the
tray
will
close
in
about
1
minute.
@
When
the
tuner
number
buttons
(preset
numbers)
are
pressed,
the
power
will
be
switched
on
in
the
same
way
and
the
system
will
enter
the
auto
off
mode.
in
this
case,
the
“TUNED”
indicator
wilt
go
off
and
10
minutes
later
the
power
will
be
switched
off.
IMPORTANT INFORMATION
@ Head Cleaning
After the cassette deck has been used for a while, powder from
the tapes and dirt adhere to the head and fower the sound quality.
Use a head cleaning cassette tape to clean.
NOTE:
Some of the cleaning sets on the market have @ strong
polishing effect which can damage the head.
4
:
.
i.
3
:
a
hs
:
g
eto
sana
dlanad
Oo
ware
Power
Supply
Weight:
Power
Supply:
Power
Consumption:
Q
m
z
m
Pe)
>
ea
2)
m
?)
=
9]
9
NY}
ul
i
© Disc Cleaning
e
Never use the following to clean discs:
© Solvents such as benzene or alcohol
e Cleaners containing abrasives
© Record sprays or cleaners
e@ Anti-static products
ee
@ Head Demagnetizing
The heads become magnetized after the deck has been used over
8 long period of time or if the heads are exposed to 8 magnetic
field. This results in noise and reduced treble. In addition, there
may be 8 reduction of the treble range of recorded tapes as well
as noise produced on these tapes.
When the heads become magnetized, use one of the cassette tape
head demegnetizers {erasers} available on the market to de-
magnetize the heads.
e For details, read the operating instructions of the demagne-
tizer.
Dust, fingerprints, or spittie on the disc can cause noise or
skipping.
tf the disc is dirty or if the player does not work properly, clean the
disc as follows:
© Hold the disc as shown in the diagram, with the signal surface
facing up (end the labelied side facing down).
Using a soft cloth, wipe the disc gently from the inside straight
towards the edges (as shown by the arrows).
e Do not wipe from the edges towards the center, or
around the disc es you would wipe records.
@ Do not use hard cloths or rub the disc forcefully. since
the signal surface is susceptible to scratches.
Recept! Hon Frequency Renge:
Receiving Sensitivity:
FM Stereo Separation:
Bass Adjustment:
Treble Adjustment:
Super Dynamic Bass:
Sacks:
Dimensions (mex.):
Weight:
Power Supply:
Power Consumption:
Amplifier (UPO-250)
Rated Output Power:
Jacks:
Dimensions (max.):
Weight:
Power Supply:
Power Consumption:
CD Player (UCD-250)
Wow and Flutter:
Sampling Frequency:
Light Source:
Power Consumption:
Cassette Deck (UDRW-250)
Type:
Heads:
Tape Speed:
Noise Reduction Circuits:
Usable Tapes:
Dimensions (max.):
Remote Control Unit (RC-154)
Type:
Number of Buttons:
Dimensions {max.):
Welght:
FM: 87.50 MHz to 108.00 MHz
AM: 622 kHz to 1611 kHz (MW), 153 kHz to 279 kHz (LW)
FM: 1,5 yV,75 ohms {SN ratio 36 dB)
AM: 20vV {SN ratio 20 dB, MW}, 35 uV (SN ratio 20 dB, LW)
40 dB {1 kHz)
100 Hz +8 dB
10 kHz +8 dB
B80 Hz +8dB
PREOUT: Output jacks
PHONO: Input jacks
DAT: Input jacks, recording output jacks
Processor: Processor input/output jacks
270 (Wi x 86 (H} x 330 {D) mm (10-5/8" x 3-25/64* x 13°)
3.2 kg {7 lbs 10 02)
AC 230 V, 50Hz, AC 240 V, 50Hz (for U.K. model)
18W
50 W + 50 W (20 Hz to 20 kHz, 8 ohm}
6.3 mm headphone jack
270 (W} x 96 (H} x 330 {0} mm (10-5/8" x 3-25/32" x 13)
4.1 kg (9 Ibs 1 oz)
AC 230 V, 60Hz, AC 240 V, S0H2 {for U.K. model)
140 W
Below measurable limits (0.001% W. Peak)
44.1 kHz
Semiconductor
270 (W) x 86 {H} x 313 (0) mm (10-5/8" x 3-25/64" x 12-21/64"}
3.1 kg (6 Ibs 13 o2)
AC 230 V, 50Hz, AC 240 V, 50Hz {for U.K. model)
15 W
Horizontal 4-track, 2-channel auto reverse stereo cassette deck
1 hard permatloy recording/ playback head, 1 hard permatioy playback head,
and 1 double-gap ferrite erase head
4.75cm/s
Dolby Band C NR
Normal, chrome, and metal tapes
270 (W) x 96 (H) x 318 (D) mm (10-5/8" x 3-25/32” x 12-33/64")
4.4 kg (9 !bs 11 02)
AC 230 V, 50Hz, AC 240 V, 50Hz (for U.K. model)
18W
infrared pulse
41 (including 1 slide switch)
60 (W) x 177 {H) x 18 (D) mm (20-23/64" x 6.31/32" x 45/64")
130 g (Approx. 6.4 02) (including batteries}
* Maximum dimensions include controls, jacks, andcovers. (W} = width, (H) = height, (D} = depth
@ For improvement purposes, specifications and functions are subject to change without advanced notice.