2 3
1. INTRODUCTION
The Bluetooth remote control for DAB is an optional accessory for the
Dension DAB+A and DAB+M devices. The remote control makes the usage
of the DAB devices as simple as the usage of an FM stereo.
1.1 First steps
If you plan on using your DAB device together with the remote control but
without the DAB application, first you need to set up your DAB device.
To do that, please follow these steps:
Bluetooth pairing:
The remote control will connect automatically to the nearest DAB+A
or DAB+M device.
Setting FM frequency:
Manual Scanning
In order to set the FM frequency, you need to follow the next steps:
► Turn the ignition ON,
► Press and hold the button for 3 seconds,
► Enter the frequency (from 87.6 [876] to 107.9 [1079]),
► Press the button to store the valid frequency,
► Switch to the selected frequency on your radio.
Automatic Scanning
You can also start an automatic FM frequency scan. To use this option, you
need to do the following:
► Turn the ignition ON,
► Press and hold the button for 3 seconds,
► Press the button.
After these steps, the device will be looking for a free frequency and will
set it automatically. This frequency can be found if you do an FM scan with
your radio.
1.2 Managing DAB+
You can perform a DAB scan by pressing the button. During the
scanning process you should see ‘DAB scan’ on the radio screen.
Navigation between stations
By pressing the and buttons, you can jump to the next or previous
station. If you press and hold these buttons, you can skip five stations at a
time (alphabetically).
Presets
You can store presets to button 1-9. To store the currently played station,
you need to press and hold one of the numerical buttons for 3 seconds.
After this, you can switch to that station directly by short pressing the
same button.
To Next Page
Loading...