DENSITY 390 - Page 17

11. Front LED’s
12. Errors
BOOT
USB
W2
W1
FIRETIME
RESET
1 heat exchanger overtemperature
2 temperature regulation fault
3 thermocouple reference fault
4 triac overtemperature
5 thermocouple error
6 eeprom error
7 missing battery
8 low battery voltage
9 main power supply missing
10 main power supply low
11 pump overcurrent
12 pump shortcircuit
13 empty fog rell
To READ out the error present:
PUSH and RELEASE the “RESET” button. Count the number of ashes on the red LED (The BEEPER will also
beep synchronously with the LED’s).
The number counted is the current ERROR of this machine.
NOTICE:
Red STEADY light = The fog rell is EMPTY or on the reserve. Or another error is present (see the list above).
See how to read
an error.
When on: the machine is armed and, if hot, it’s ready to shoot.
ARM
FAULT
HEATING
When on: something is wrong. (See section 12. Errors below)
When on: the machine is hot and ready for the fog emission.
When ashing: the heating process is in progress. In this step, the Density machine is
heating but is not ready to shoot.
Blue LED
Red LED
Green LED
page 17/20
www.densityglobal.com | help@densityglobal.com
Version 1.1.4