DENSITY 390 - Connection diagram examples

6.1. Connection diagram examples
COM 3COM 2COM 1
W3
NO
NC
W4
NO
NC
W5
NO
NC
W6
NO
NC
W7
NO
NC
BOOT
USB
C PLUS PCB
W2
N
L
FIRETIME
ACTION DAYTIME ACTION NIGHTTIME
INTRUDER SYSTEM DISARMED
FOG GENERATOR DISARMED
RESET
0V
ARM
PRIMARY TRIG
+ 12V
MAINS
FUSE
F4
INTRUDER SYSTEM ARMED
FOG GENERATOR ARMED
INTRUDER SYSTEM IN ALARM
FOG GENERATOR ARMED
FOG GENERATOR SHOOTING
0V
ARM
+ 12V
0V
ARM
+ 12V
12V OUTINPUTOUTPUTPIR
ARM +
ARM -
TRG +
TRG -
IN 1 +
IN 1 -
EMPC
EMP
FLTC
FLT
TMPC
TMP
FVLC
FVL
AUXC
AUX
PIR +
PIR -
PIRC
1
2
3
4
5
6
7
W1
ACTION ALARM
PRIMARY TRIG
PRIMARY TRIG
IN 0 +
IN 0 -
+ 12V
GND
DIPSWITCH 6 MUST BE ON TO
ENABLE NC (Normal Closed) ACTION
IMPORTANT!
DIPSWITCH 8 MUST BE OFF TO
ENABLE NORMAL OPERATION MODE
8
ARM and SHOOT:
To control the fog generator, you use the ARM input on the
fog generator. When you ARM the fog generator, it will be
ready to SHOOT when it is HOT (Green LED must be on and
STEADY).
When you ARM the fog generator, the Blue LED will come on
steady. Now the fog generator is ready and Armed.
To SHOOT (when Ready and ARMED), you activate the TRG
input.
Shooting time as set on the SHOOT-timer.
page 8/20
www.densityglobal.com | help@densityglobal.com
Version 1.1.4