Desoutter CVI3 Vision User Manual

Appendix - User info codes _01/2016- 68 -
Code
no.
Description Resolution procedure
916 Workgroup not authorized 1- You need to connect an epod3 on the Workgroup Primary controller
917 Invalid accessory
conguration
1-The accessory conguration is not correct
2-Check type of elements and events associated
918 Emergency stop activated 1- The emergency stop has been activated
2- Check the M8 connector
919 additional transducer
conguration error
1- The additional transducer's maximum torque is lesser than the embedded transducer's
maximum torque
2- The Pset uses an additional transducer though non is installed on tool
920 Controller reset to factory
settings
ePod automatic backup must be congure again if needed
921 Pset execution is not
authorized
1-Check used features allowance
2-Contact your Desoutter representative for support
922 Additional transducer span
failure
1- Span value from additional torque sensor is outside bounds.
2 -Try once again to start the tool with no mechanical constraints. If the problem occurs
again, contact your Desoutter representative for support
923 Additional transducer offset
failure
1- Offset value from additional torque sensor is outside bounds.
2- Try once again to start the tool with no mechanical constraints. If the problem occurs
again, contact your Desoutter representative for support.
924 Tool calibration required 1-Perform a calibration of the tool on CVI3

Desoutter CVI3 Vision Specifications

General

Brand	Desoutter
Model	CVI3 Vision
Category	Controller
Language	English