4
1]
Consultation Calls
You can also carry out this code-number procedure during consultation calls:
GR press the R key during the current call
2]
Connecting Two External Parties with Each Other
If you connect two external parties whom you called, you will be charged for the cost of the
resultant call.
3]
MSN Call Forwarding
You can forward several MSNs together to an external telephone number. The individual MSNs
are separated using
* . You do not need to enter the full MSNs - the last unique digits are all you
need, as this is sufficient to distinguish them from one another.
4]
Doorbell
Several doorbells can be configured in the OpenCom 100/OpenCom X300. You can forward these
doorbells using the appropriate code number procedure. The user guide for the standard ter-
minals provides an overview.
Call waiting on/off
(= call waiting protection off/on)
on:
H*43#
off:
H#43#
Remote service on:
*19*Z (system PIN) #
off:
#19#
Hotel
Room has been cleaned *170
Wake-up call on/off on:
H*55*(time, e.g. 0615)
off:
H*55#
Others
Activating automatic time control
H*8#
Manually setting a time group
H*8*Z(number of the time group, e.g. 1 )#
Changing the user PIN
H*99*Z (old user PIN) *
Z (new user PIN) *Z (new user PIN) #
Configuring IP address
*182Z (system PIN)
* 111 * 222 * 333 * 444 #
Configuring network mask *183Z (system PIN)
* 111 * 222 * 333 * 444 #
Restart
*185Z (system PIN) #
Show firmware version (revision)
*186
Show own port
*187
Show system type
*188
DeTeWe Systems GmbH As of June 2006 Subject to changes
oc_kba_codes_en.fm Seite 4 Freitag, 20. Oktober 2006 3:50 15
To Previous Page
Loading...
