1
OpenCom 100/OpenCom X300:
Code-number Procedures
You can use the code-number procedures on every terminal (these are standard and ISDN
terminals as well as system telephones). On a system telephone many procedures can be carried
out comfortably by using the system telephone’s menu.
Dial out
Making internal calls (on automatic
seizure of external line)
H**Z (internal tel. no.)
1]
Deactivating Least Cost Routing
(LCR)
H##Z (dialling code, tel. no.)
1]
VIP call
H*#Z (internal tel. no.)
1]
Calling the entrance intercom
H*101 (not with OpenCom 107)
1]
Calling a “DoorLine” entrance
intercom
H*102
1]
Door opener
H*11
1]
Keypad dialling
H*12Z (keypad code digits)
1]
Announcement
H*13*Z (internal tel. no.) #
1]
Calling Line Identification
Restriction (CLIR) by call
H*14Z (tel. no.)
1]
Baby call on:
H*53* (external access code, e.g. 0 )
Z (destination tel. no.) #
off:
H#53#
Speed dialling
H*7Z (speed dialling no.)
1]
alternatively:
H*7*Z(speed dialling no.) #
1]
Dial in
Leaving a callback request
(a/b, DECT-GAP)
on:
G*37#
alternatively:
G6h
off:
G#37#
Pick-up
H*0#G…
1]
Pick-up selective
H*0*Z (internal tel. no.) #G…
1]
Logging out of/into all hunt groups log out:
H*31#
log in: H#31#
Logging out of / into individual hunt
groups
log out:
H*31*Z (internal tel. no.) #
log in:
H#31*Z (internal tel. no.) #
oc_kba_codes_en.fm Seite 1 Freitag, 20. Oktober 2006 3:50 15
To Next Page
Need help?
General
