deuter Attack 20 - Fitting and Maintenance; Fitting the Pack and Carry Position; Important Safety Tips

GB
fitting the pAck And
fine-tuning the cArry position:
The Shield System protector can only deliver the specified protec-
tion when correctly positioned. Please ensure that it does not slip
out of position. [see illustration on inside front cover
B
]
1
First, loosen all the adjuster straps. Shoulder the rucksack, position the
waist belt, then fasten and adjust it to give a snug fit.
The mid-point of the waist belt should lie on the hip bone and not above
or below the hip, since this would impair the freedom of movement.
2
The back pad should be positioned vertically and in the centre of the
back.
3
The shoulder strap, chest strap and waist belt must be adjusted for a snug
fit in order to provide a comfortable and compact carry.
To offer maximum protection the shield system should be worn correctly.
Only areas covered by the protector will offer sufficient protection [see illu-
stration on inside front cover
a
]
importAnt sAfety tips:
• The rucksack is not positioned centrally or is too high/low on the back.
Shoulder straps, chest strap and waist belt are not fastened/ not snugly
adjusted. [see illustration on inside front cover
C
]
• Sharp objects such as: Screwdrivers, tool and other sharp objects can
affect the protection function.
• Glass bottles, potentially explosive items (such as pressurised containers
and gas cartridges) and easily inflammable or corrosive substances also
have a potentially negative effect on the protective system.
• All straps and buckles should be securely fastened when the rucksack is in
use.