To::,redu.ce
the,,,risk of fire,
eleGtric shock
and
pe&nal
:ihjury
when
usihg:,,electical:,:tools,
the following
basic
safety
pre:cautio'nS,,should
always,
be'takeh';,,,.
,,::,i
",,::,,
.You
must have
been trained to operate this
machine
before
using it.
.
Machines can
cause flammable
materials and vapors
to burn.
Do not use the
machine with or
near sol-
vents,
thinners, fuels,
or other flammable
materials.
.
To
prevent
the
risk of fire or explosion:
a) Keep the machine
away from
sources
of ignition,
as they could
create an explosion
during use.
b) Keep the work
area well
ventilated. Poorly ventila-
ted work areas
can create
an explosive atmosp-
here when
they contain
solvents, alcohol, thinners,
certain finishes or
any kind of
combustible mate-
rial.
c) Never leave
a full dust
bag in the machine.
Remove the dust bag when
you
have finished
your
work.
d)
Empty the dust bag when
it is 1/3 full.
e) Always empty
the sanding dust
into a
metal
contai-
ner. This container
must
be outside the building.
f) Do not
put
the contents of
the dust bag into a fire
or furnace.
g)
Use a hammer and
punch
to set allthe nails flush
against the
floor so that the sanding drum will not
touch them and create
sparks which might cause
a fire in the
dust bag.
Read
these instructions
carefully before
operating
or attempting
to
carry out
any service or maintenance
procedure
on
this
product.-
.
Do not
use the machine
if it is not
completely
assem-
bled.
.
To
prevent
electric
shocks
and
personal
injury,
always disconnect
the
power
supply
before
chan-
ging
the sandpaper,
emptying
the dust
bag, leaving
it unattended
or
attempting
any maintenance
or ser-
vice of the
machine.
.
To
prevent
electric
shocks, avoid
contact with
groun-
ded surfaces,
i.e.
pipes,
radiators,
refrigerators,
etc.
.
Do not expose
the
machine to rain.
Keep the electri-
cal
parts
dry.
.
The
machine should
be stored
in a dry
place
and out
of
the reach of children.
.
Check
the cable
and
plugs
and
replace them
if
damaged.
Do not
use the machine if
the cable is
damaged. Keep
the cable away
from heat, oil, water
and sharp
edges.
.
Always
connect the
machine to a
grounded
power
supply.
Never disconnect
the
ground
cable
from the
machine.
.
Always use
a cable with 3
x 1,5 mm of section
and
connect
the machine
to a
grounded
plug.
Ensure
that the
plug
really
does have a
ground
connection.
.
Make
sure that the
power
switch is in
the
"O"
posi-
tion before
connecting the
cable to the electrical
power
supply.
To Next Page
Loading...