DEVI DEVIcomfort 10T - Page 5

Installation Guide DEVIcomfort 10T
• be stated in any electrical documentation
following the installation.
3 Installation guidelines
• It is not recommended to install DEVIcomfort
10T at temperatures below -5°C.
• If walking on the elements is necessary
during installation and carefully purring of
screed, only use soft shoes.
• Be careful not to damage the thin mat with
sharp tools, shovel, bucket etc.
• Minimum distance between heating ele-
ments; cable and conductive parts; cable
and other heating sources such as hot water
pipes and chimneys, must be at least 50 mm.
• Heating elements may not touch or cross
themselves or other heating elements.
• Cable bending diameter must be at least
40mm.
• The heating elements are not to be installed
on irregular surfaces
• The suboor construction must be secure to
avoid relative movement after installation.
• Prepare the installation site properly by
removing sharp objects, dirt, etc.
• The thin mat must be fully embedded in
screed (ne concrete).
• Do not lay DEVIcomfort 10T under walls and
xed obstacles.
• Do not place objects that will cause a ther-
mal block e.g. furniture, thick carpets, etc.
Min. 6 cm air is required
• The ooring must not have a thermal insula-
tion value of more than R < 0.18 mK/W
corresponding to 1.8 Tog.
• Keep DEVIcomfort 10T clear of insulation ma-
terial, other heating sources and expansion
joints
• Position the thin mat so that it is at least half
the C-C distance from obstacles.
• DEVIcomfort 10T must always be in good
contact with the heat distributor (e.g.
concrete)
• If additional securing is required hot melt
glue, double adhesive tape or tile glue can
be used.
• When the heating element reaches the area
boundary just turn and continue the roll-out.
Do not cut the heating cable.
• The heating element and especially the
connection must be protected from stress
and strain.
4 Application overview
The heating element DEVIcomfort™ 10T complies
with the EN/IEC 60335-1 standard + EN/IEC 60335-
2-96.
Regarding other types of applications please
contact your local DEVI sales company.
GB
DE
DK
EE
FI
LT
NO
PL
RO
SE
5DEVI VIJUB102