To Next PageTo Next PageWhy is my DeVillbiss Air Power Company Nail Gun nailer/stapler misfiring or sinking two nails/staples at once?
This issue may arise if the air pressure is too high for your model. Try adjusting the air pressure to the correct PSI. Also, the trigger action might be faulty. Consider purchasing a Trigger Repair Kit to repair it.
What to do if my DeVillbiss Air Power Company Nail Gun tool fails to drive fasteners?
Several factors can cause this. The driver guide could be worn or damaged, requiring replacement with a Driver Blade Kit. Other potential issues include a damaged feed pawl, worn feed pawl spring, or damaged feed pawl pin. Also, check for adequate airflow and pressure, and inspect the piston seal and trigger valve seal for wear or damage. Air leaks can also prevent the tool from driving fasteners, so tighten any loose screws and fittings and replace the cap seal if it's leaking.
General| Brand | DeVillbiss Air Power Company |
|---|---|
| Model | 2by4 Contractor Series |
| Category | Nail Gun |
| Language | English |
Key warnings and precautions before operating the equipment.
Explains symbols and terms (Danger, Warning, Note) used in the manual.
Step-by-step guide on how to use the contact trip firing mechanism.
