DeWalt D36000 - Technical Data; Definitions: Safety Guidelines; General Power Tool Safety Warnings; Work Area Safety

5
ENGLISH
Cut Indicator (Fig. Q)
The cut indicator
39
assists in aligning long and diagonal cuts by showing where the cutting
wheel will exit the cut. The cut indicator can be used multiple times before adjustment
isnecessary.
1. Loosen locking screw
50
.
2. Rotate cut indicator to expose uncutsurface.
3. Tighten lockingscrew.
Depth of Cut (Fig. A, M)
1. Loosen head lock knob
4
.
2. Adjust depth of cut knob
40
until the cutting wheel is at least 3/16” (5mm) below the
cartsurface.
3. With the unit turned off, push the cart past the cutting wheel and ensure that the cutting
wheel does not touch thecart.
4. Adjust the depth of cut knob and tighten the locking wing nut
51
, then the head lock
knob
4
.
Fig. P
4
33
43
42
Bevel Pointer (Fig. P)
Loosen the 0° bevel pointer screw
43
and rotate the bevel pointer
42
to the correctlocation.
Cart Rolling Resistance (Rail Adjustment) (Fig. O)
1. Loosen the four rail height screws
48
.
2. Adjust the two rail height adjusters
47
until cart movessmoothly.
3. Tighten the fourscrews.
Fig. O
46
48
47 46
Cutting Parallel to Cutting Cart (Fig. N, O)
1. Lay a 90° square flat on the cutting cart surface with one end against the cart fence
36
.
Roll the cart forward so that the square is aligned to the cutting wheel, keeping the square
against thefence.
2. If the cutting wheel is not 90° to the cart fence, the rail will needadjustment.
3. Loosen the four rail assembly mounting screws
46
.
Fig. N
36
Cutting Wheel 45° to the Cart (Fig. M)
1. Loosen bevel locking knob and rotate the cutting head to45°.
2. Put a 45° guide on the cutting cart surface next to the cutting wheel. If it is not at 45°,
adjust the 45° bevel adjustment screw
45
with the supplied wrench until the cutting
wheel is 45° to the cartsurface.
3. With saw turned off, ensure that the cutting wheel does not touch either side of the
groove in the cutting cart by pushing the cart past the cuttingwheel.
Fig. M
40
51
41
44
45
Fig. L
Adjustments
Cutting Wheel Square to Cart (Fig. L, M)
1. Open the cutting wheel cover
5
using the cutting wheel cover knob
20
.
2. Place a 90 degree square on the cutting cart against the cuttingwheel.
3. If the gap is not consistent, loosen the bevel lock knob
41
and adjust the 0° bevel
adjustment screw
44
with supplied wrench until the cutting wheel is 90° to the
cartsurface.
4. Ensure that the cutting wheel does not touch either side of the groove in the cutting cart
by pushing the cart past the cutting wheel with saw turnedoff.
Fig. K
20
5
6
31
30
32