DeWalt DC515 - Page 29

27
Package contents
The package contains:
1 Vacuum cleaner
1 Wide nozzle
1 Crevice tool
1 Instruction manual
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fi g. A)
1 On/off switch
2 Hose
3 Nozzle
4 Vacuum inlet
5 Tank
6 Battery pack (not included)
INTENDED USE
Your DC515 cordless vacuum cleaner has been
designed to vacuum dry and wet substances in
professional applications.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
This vacuum cleaner is a professional power tool.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators
use this tool.
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate.
ASSEMBLY AND ADJUSTMENTS
WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only DEWALT battery
packs and chargers.
Battery pack (fi g. B)
Battery type
The tool will operate on battery packs of 18 volts.
Refer to the table in the back for a selection of
applicable battery packs.
WARNING: Use only DEWALT battery
packs and chargers.
Inserting and removing the battery pack
• Insert the battery pack (6) into the tool until it
clicks in place.
• To remove the battery pack, press the two
release buttons (7) simultaneously and pull the
pack out of the tool.
Battery pack condition
• Make sure your battery pack is (fully) charged.
If the battery pack does not produce suffi cient
power, charge the battery pack following the
instructions in the manual of the charger.
Removing and refi tting the hose (fi g. C)
Removing
• Take the hose nozzle (9) out of the fi tting (10).
• Turn the connecting piece (8) counterclockwise.
• Pull the hose off the vacuum inlet (4) at the
connecting piece.
Re tting
• Insert the connecting piece (8) into the vacuum
inlet (4).
• Turn the connecting piece clockwise to fi x the
hose in position.
• Insert the hose nozzle (9) into the fi tting (10).
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
Switching on and off (fi g. A)
• To switch the tool on, set the on/off switch (1) to
position I.
• To switch the tool off, set the on/off switch (1) to
position O.
Vacuuming (fi g. A)
• Empty and clean the tank (5) before use.
• Ensure the hose (2) is mounted correctly.
• Move the nozzle (3) over the surface to be
cleaned. If necessary, the hose (2) can be
operated for confi ned spaces.
ENGLISH