DeWalt DCB1102MDR - Page 28

26
ENGLISH
• Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way. Take
it to an authorised servicecentre.
• Do not disassemble charger; take it to an authorised
service centre when service or repair is required.
Incorrect reassembly may result in a risk of electrical shock,
electrocution orfire.
• In case of damaged power supply cord, the supply cord
must be replaced immediately by the manufacturer,
its service agent or similar qualified person to prevent
anyhazard.
• Disconnect the charger from the outlet before
attempting any cleaning. This will reduce the risk of
electric shock. Removing the battery pack will not reduce
thisrisk.
• NEVER attempt to connect 2chargerstogether.
• The charger is designed to operate on standard
230V household electrical power. Do not attempt to
use it on any other voltage. This does not apply to the
vehicularcharger.
• Take care to ensure that the charger is standing in a
steady, secure position. A falling battery or charger may
present a risk of injury to yourself and/orothers.
• The location in which the charger is used should be
clean and dry. Use of a charger in a dirty or wet area could
result in risk of fire, electric shock, orelectrocution.