DeWalt DCB1102MDR - Page 31

29
ENGLISH
C
Lubrication
Your power tool requires no additionallubrication.
MAINTENANCE
Your power tool has been designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends upon proper tool care and
regularcleaning.

WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect battery pack before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can causeinjury.
The charger and battery pack are notserviceable.
Electronic Protection System
XR Li‑Ion tools are designed with an Electronic Protection System that will protect the
battery pack against overloading, overheating or deepdischarge.
The tool will automatically turn off if the Electronic Protection System engages. If this
occurs, place the lithium‑ion battery pack on the charger until it is fullycharged.
Mounting
These chargers are designed to sit upright on a battery or to be mounted to a wall. If
wall mounting, locate the charger within reach of an electrical outlet, and away from a
corner or other obstructions which may impede air flow. Use the arrows on the cord tag
as a template for the location of the mounting screws. Mount the charger securely using
drywall screws (purchased separately) at least 25.4mm long with a screw head diameter
of 7–9mm, screwed into wood to an optimal depth leaving approximately 3.5mm of the
screw exposed. Align the slots on the back of the charger with the exposed screws and fully
engage them in theslots.
NOTE: Only wall mount DCB1102 charger with the charging lights pointed upward toward
theceiling.
NOTE: Do not attempt to mount DCB1102 under or on top of a bench or table.