DeWalt DHS790 - Rail Guide Adjustment (Fig. A); OPERATION; Battery and Power Supply Installation

11
ENGLISH
Fig. R
53
20
59
58
Installing and Removing the Corded Power Supply into and from
Tool (Fig.S–U)
Before inserting the corded power supply into your tool, remove the end of the dust cover
59
from the tool's corded power supply receptacle
58
. Pull the dust cover away from the tool’s
corded power supply receptacle so that it does not interfere with insertion of the corded power
supply. Inspect the corded power supply receptacle for debris. Debris inside the receptacle
can prevent the corded power supply from fully seating. If debris is present, clean it using low
pressure air. Refer to Cleaning the Corded Power SupplyReceptacle.
NOTICE: The corded power supply is for AC power sources only when used with this
tool. Use with DC power sources could result in damage to thetool.
To install the corded power supply into your tool:
1. With the corded power supply unplugged, align its AC connector with the tool's corded
power supply receptacle
58
then snap intoplace.
Fig. S
58
57
56
59
2. Ensure that it is fully seated in the tool and does notdisengage.
3. Attach the dust cover
59
to the dust cover holder (
60
Fig.T) in the corded powersupply.
4. Secure the cord clip
56
into the tool's cord holder (
55
, Fig.U). Firmly press the clip into
theholder.
5. With the tool turned off, plug the corded power supply into a standard 120V household
electric power outlet. Do not attempt to use the corded power supply on any othervoltage.
6. Use the tool according to the tool instructions, making sure the cord is located so that it will
not be stepped on, tripped over, or otherwise subjected to damage orstress.
7. To remove the corded power supply from the tool, first unplug the corded power supply
from the outlet, then press the release button
57
and firmly pull the corded power supply
out of the tool. Firmly press the end of the dust cover
59
into the tool’s corded power supply
receptacle
58
.
Fig. W
PROPER CUT
PROPER CUT
IMPROPER CUT
IMPROPER CUT
IMPROPER CUT
Fig. X