EasyManua.ls Logo

DeWalt DW060 - Page 41

DeWalt DW060
104 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
41
ENGLISH
Use only the correct size of batteries. When replacing, do not mix old
batteries with new ones.
Under extreme conditions, battery leakage may occur. When you notice
liquid leaking out, proceed as follows:
- Carefully wipe the liquid off using a cloth. Avoid skin or eye contact.
Do not swallow.
- In case of skin or eye contact, rinse the liquid off with clean flowing
water for at least 10 minutes and contact a doctor.
Fire hazard! Avoid short-circuiting the contacts of a removed
battery.
Additional safety instructions for lasers
This laser complies with class 2 according to EN 60825-1:1994+A11.
Do not replace a laser diode with a different type. If damaged, have the
laser repaired by an authorised repair agent.
Do not use the laser for any purpose other than projecting laser lines.
An exposure of the eye to the beam of a class 2 laser is considered safe for
a maximum of 0.25 seconds. Eyelid reflexes will normally provide adequate
protection. At distances over 1 m, the laser complies with class 1 and thus
is considered completely safe.
Never look into the laser beam directly and intentionally.
Do not use optical tools to view the laser beam.
Do not set up the tool at a position where the laser beam can cross any
person at head height.
Do not let children come in contact with the laser.
Labels on tool
The following pictograph is shown on the tool:
Read the instruction manual before use

Other manuals for DeWalt DW060

Related product manuals