43
ENGLISH
The warnings should read as follows:
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
• If the warnings are in a foreign language, proceed as follows:
– Draw the required label from the sheet.
– Carefully place the label over the foreign language.
– Press the label in place.
Assembly and adjustment
Replacing batteries (fig. C)
The attachment uses batteries of type LR14 (C).
• Loosen and remove the screws (5).
• Remove the battery compartment cover (6).
• Take out the battery holder (7).
• Replace the batteries (8). Make sure the new batteries are placed as
indicated .
• Replace the battery holder (7).
• Put the battery compartment cover in place.
• Replace the screws and tighten them.
When replacing batteries, always replace the complete set.
Do not mix old batteries with new ones. Preferably use alkaline
batteries.
Setting up the tool (fig. D1 - D3)
The tool facilitates various set-ups, making it useful for several applications.
To Next Page
Loading...
