38
ENGLISH
Aligning the laser beams
The laser beams can be aligned with the walls or at an offset from them.
• Align the laser line of either one of the laser beams with the position
mark or reference point. Move the tool as required.
OPERATION
Instructions for Use
WARNING: Always observe the safety instructions and
applicable regulations.
• Always mark the centre of the laser beams.
• Extreme temperature changes cause movement of internal parts that
may affect the accuracy of the tool. Regularly check the accuracy while
using the tool under these circumstances.
• If the tool has been dropped or has tipped over, check whether there is
damage by performing the fi eld calibration checks. See “Maintenance”.
Prior to operation:
• Carry out the fi eld calibration checks to confi rm its accuracy.
• Make sure the tool has been set up securely.
Switching on and off (fi g. A)
• To switch the tool on, press the on/off switch (1).
• To switch the tool off, press the on/off switch (1) again.
Establishing square angles (fi g. D1)
• Position the tool on the surface.
• Align the laser beams as necessary.
• The laser lines can be used as references to a square angle.
Squaring walls (fi g. D2)
• Position the tool on the surface in front of the corner.
• Align the intersection point of the laser lines (8) with the corner.
• Proceed as described above.
To Next Page
Loading...
