EasyManuals Logo

DeWalt DW168F Instruction Manual

DeWalt DW168F
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
VISCOSITY-AMBIENTTEMPERATURE CHART
: , : =3Ü
aw:3o i i
"F -20 0 20 40 60 80 100
_C -28.8 -17.7 -6.6 4,4 15.5 26.6 37.7
TO ADD OIL (FIG. 1)
I, Refer to Viscosity-Ambient Temperature Chart above for correct
viscosity.
2. Remove dipstick.
3. Slowly add recommended oil, see specifications for oil capacity.
NOTE: If the oil is added too quickly, it will overf{ow and appear
to be full,
See To Check Oil under Maintenance for instructions.
TO ADD FUEL
_J,WARNING: Risk of explosion or fire. Gasoline vapor is highly
flammable. Refuel outdoors only in well-ventilated areas. Do not
refuel or check gasoline level while the engine is running. Do not
store, spill or use gasoline near an open flame, a source of sparks
(such as welding) or near operating electrical equipment.
t. Remove fuel cap (A).
2. Add fresh, clean, regular unleaded gasoline
w{th a minimum of 86 octane to the fuel
tank (B). Do not fill above the shoulders
on the debris screen (P) as shown. NOTE;
The debris screen protects theengine from
dirt and debris, onty remove screen when
cleaning. See Cleaning Debris Screen
under Maintenance for instructions.
NOTE; Do not mix oil with gasoline.
3. Replace the fuel cap on the tank. Turn the
cap clockwise until it stops.
OXYGENATED FUELS
A B
Some conventional gasolines are blended with alcohol or an ether
compound. These gasolines are collectively referred to as oxygen-
ated fuels. To meet clean air standards, some areas of the United
States and Canada use oxygenated fuels to help reduce emis-
sions.
If you use an oxygenated fuel, be sure it is unleaded and meets the
86 m{nimum octane rating requirements. Before using an oxygen-
ated fuel, try to confirm the fuel's contents. Some states/provinces
required this informationto be posted on the pump.The following are
the EPA approved percentages of oxygenates:
Ethanol (ethyl or grain alcohol) 10% by volume. You may use
gasoline contain{ng up to 10% ethanol by volume. Gasoline contain-
ing ethanol may be marketed under the name gasohol.
CAUTION: Risk ofproperty damage. DO NOT use E85 fuel
MTBE (methyl tertiary butyl ether) 15% by volume. You may use
gasoline containing up to 15% MTBE by volume,
Methanol (methyl or wood alcohol) 5% by volume. You may use
gasoline containing up to 5% methanol by volume as long as it also

Other manuals for DeWalt DW168F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DeWalt DW168F and is the answer not in the manual?

DeWalt DW168F Specifications

General IconGeneral
BrandDeWalt
ModelDW168F
CategoryEngine
LanguageEnglish