See technical data for charging time
Package contents
The package contains:
1 Radio/charger
1 Instruction manual
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your DW911 radio/charger accepts DEWALT NiCd
and NiMH battery packs ranging from 7.2 to 18 V.
1 Volume control
2 Mode selector
3 Station selector
4 Latch
5 Scale
6 Charging indicator (red)
7 Battery pack
Electrical safety
Make sure that the voltage of your charger
corresponds to that of your mains.
Your DEWALT charger is double
insulated in accordance with EN 60335;
therefore no earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
DEWALT repair agent or a qualified electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 3 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• Never attempt to open a battery pack for any
reason.
• Use only chargers labelled “NiMH” or “NiMH +
NiCd” to charge DEWALT NiMH battery packs.
Labels on charger and battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
100%
Battery charging
100%
Battery charged
Problem charging or too cold
NiM
+
Charges NiMH and NiCd battery packs
Do not probe with conductive objects
Do not charge damaged battery packs
Read instruction manual before use
Use only with DEWALT battery packs,
others may burst, causing personal injury
and damage
Do not expose to water
Have defective cords replaced
immediately
+40 ˚c
+4 ˚c
Charge only between 4 °C and 40 °C
Discard the battery pack with due care
for the environment
To Next Page
Loading...
