DeWalt DXCMV5076055 - Page 27

27
English
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
25
Low voltage motor Furnish adequate powder.
26
Bad check valve Replace check valve.
27
Seized pump Contact a D e WALT factory service center or a D e WALT authorized
service center.
28
Oil level too high Reduce to proper level. See Compressor Pump Oil under
Maintenance.
29
Poor ventilation Relocate compressor to an area with cool, dry, well circulated
air, at least 12 in. from nearest wall.
30
Dirty cooling surfaces Clean all cooling surfaces thoroughly.
31
Too much back pressure in tank. Open drain valve when starting motor.
32
Compressor too cold Move compressor to a warmer location.