DeWalt DXGNR7000 - Test 20 - Check Ignition Spark

Section 3 Engine Diagnostic Tests
Diagnostic Repair Manual 27
Problem 20 – Unit Will Not Idle
Problem 21 – Unit RPM Will Not Increase From Idle
*Acceptable running limits for the engine are between 59-62 Hertz.
REPLACE FAULTY
COMPONENT
GOOD
FOUND BAD COMPONENT
TEST 36 – TEST
IDLE CONTROL
(STEPS 1 - 11)
FOLLOW
TROUBLESHOOTING
PROCEDURES
BAD
TEST 1 – CHECK
NO-LOAD VOLTAGE
AND FREQUENCY
*Acceptable running limits for the engine are between 59-62 Hertz.
REPLACE FAULTY
COMPONENT
FOUND BAD COMPONENT
TEST 36 – TEST
IDLE CONTROL
(STEPS 12 - 13)