DeWalt ToughSystem 2.0 RADIO + CHARGER - Connecting an Auxiliary Audio Device; Appliance Settings

21
EN
EN
Connecting to Bluetooth
®
. 1 Press the Home button and select BT as the audio source.
. 2 Press the Bluetooth
®
touch button to disconnect any other connected device.
. 3 Enable Bluetooth
®
discovery on the audio device you wish to connect.
. 4 Scan for the TOUGHSYSTEM
™
2.0 RADIO + CHARGER, display name:
TOUGHSYSTEM_XXXX (where XXXX is an identifier of the device) and select it.
Once paired and connected, the connected device name is displayed on the screen.
Disconnecting the Connected Device
From the Bluetooth
®
screen press the Bluetooth
®
touch button. The Bluetooth
®
LED
changes from yellow to gray.
Changing the Connected Device
. 1 From the Bluetooth
®
screen, press the settings touch button. A list of all recognized
mobile devices appears.
. 2 Press the touch button next to the required user name. The device will be discovered and
connected (if Bluetooth
®
is enabled on the audio device).
Playing Audio through Bluetooth
®
Any audio (as music) stored on a mobile device that is connected via Bluetooth
®
to the
TOUGHSYSTEM
™
2.0 RADIO + CHARGER can be streamed from the connected device to the
TOUGHSYSTEM
™
2.0 RADIO + CHARGER.
After connecting a mobile device via Bluetooth® do one of the following:
• Press the Selection Dial to play the last played song.
The song name is displayed on the screen.
• Press the Left or Right buttons
to move up/down your songs (audio) list.
CONNECTING AN AUXILIARY AUDIO DEVICE
. 1 Connect a 3.5 mm audio cable (not provided) between the 3.5mm Auxiliary input jack and
the output jack of your audio device.
. 2 Press AUX as the audio source. The screen displays an AUX figure.
. 3 Operate the audio through the connected device.
APPLIANCE SETTINGS
. 1 Press the Home button
. 2 Press the Settings touch button
Settings to the following can be performed: System, Sound, Display, Bluetooth
®
, FM.