DeWalt ToughSystem 2.0 RADIO + CHARGER - Standards and FCC Details

8
EN
EN
LIST OF STANDARDS
The DEWALT
®
TOUGHSYSTEM
™
2.0 RADIO + CHARGER complies with the following standards:
• ANSI/UL60065:2015 Ed.8
• CAN/CSA-C22.2 No. 60065:2016 Ed.2
• ANSI/UL1310 (6th Edition rev. December
12, 2014)
• CSA C22.2 No.223-M91 (Rev. September 2013)
• IC RSS-247 Issue 2, February 2017
• ICES-003, Issue 6: 2016
• UL 2595:2015 Ed.2
• FCC part 15 Certication: (ANSI C63.10
:2013)
• FCC ID: 2ANWFDWST08820
• IC: 23237-DWST08820
FCC
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1). This device may not cause harmful interference, and
(2). This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
3. This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Compliance
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identier Trade Name: DEWALT® TOUGHSYSTEM®, Model No.: DWST08820
Responsible Party – U.S. Contact Information
Stanley Black & Decker, Inc.
400 Executive Blvd S
Southington CT 06489 United States
WWW.DEWALT.COM
WARNING: To reduce the risk of re or electric shock, DO NOT expose this appliance to
direct rain or moisture. Use only in dry locations.
TOUGHSYSTEM
™
2.0