DeWalt ToughSystem DWST1-75663 - Playing Audio from an External Device (AUX; Bluetooth); Connecting an Auxiliary Device; Connecting a Device through Bluetooth; MAINTENANCE

12
ENGLISH
Protecting the Environment
w
Separate collection. Products and batteries marked
with this symbol must not be disposed of with
normal householdwaste.
Products and batteries contain materials that
can be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
ourenvironment:
Optional Accessories

WARNING: Since accessories, other than those offered
by
DeWALT
, have not been tested with this product, use
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only
DeWALT
recommended
accessories should be used with thisproduct.
Consult your dealer for further information on the
appropriateaccessories.
D
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing thisprocedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non‑metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into aliquid.
C
Lubrication
Your power tool requires no additionallubrication.
MAINTENANCE
Your radio has been designed to operate over a long period of
time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regularcleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start‑up can causeinjury.
The radio/charger and battery pack are notserviceable.
4. Press the selection dial again to enter the Sound
settingsscreen.
5. Adjust to the desired setting by rotating the selection dial
clockwise/counterclockwise.
6. Press the selection dial to scroll through the sound setup
options. Pressing
 
saves the selectedsetup.
Playing Audio from an External Device (AUX/
Bluetooth)
The appliance can be used to play sound from an external
device, through its built-in speakers, in one of two
connectionoptions:
‑ Auxiliary
‑ Bluetooth
NOTE: The top compartment can also be used to store, protect
and charge some portable audio devices, such as a smart phone
or MP3 player. The USB power port can charge/power most
devices that can accept power through a USB charging port
(5V/1A).
Connecting an Auxiliary Device
1. Connect a 3.5 mm audio cable between the auxiliary input
jack and the output jack of your audiodevice.
2. Press the audio source button
 
until AUX isdisplayed.
3. Operate the audio through the connecteddevice.
Connecting a Device through Bluetooth
The appliance can connect to Bluetooth capable audio devices
through Bluetoothcommunication.
NOTE: The Bluetooth mode can store up to 8users.
1. Enable the Bluetooth of the audio device to beconnected.
2. Press the audio source button
until the Bluetooth
symbol is displayed

, or press the Bluetooth button


. This operation enters the Bluetooth mode.The
Bluetooth button

blinksslowly.
3. Press the Bluetooth button
 
for 3seconds to make
it discoverable. A discoverable signal sounds and the
Bluetooth button


blinksfast.
4. Look for the appliance (display name: ToughSystem Music)
on the audio device to be connected, and select it. Once
connected a connected signal sounds. The Bluetooth
symbol is displayed on the LCD screen and the Bluetooth
button lights in steadyblue.
5. Operate the audio through the connected device. The
next time this device is in its Bluetooth ON mode, it will
automatically discover and connect to the appliance.
NOTE:The appliance connects to the last connected device.
A connected signal sounds. If the last connected device is
not available, the Bluetooth button blinks until found by
one of the other previously connected devices. NOTE:To
disconnect from a device and become discoverable for
other devices, press the Bluetooth button
 
for 3seconds,
or press the selection dial and select MakeDiscoverable.