DeWalt XR DCMWSP156 - Mower Assembly and Adjustments; Handle Adjustments and Storage

55
ENGLISH
55
Grass Collection Bag (Fig. M)

DANGER: Turn unit off and remove safety key and
batterypacks.
1. Lift the rear door cover
21
, remove mulching plug
24
,
and place the grass collection bag
22
onto the mower
so the bag lugs
33
slide into the slots
39
on the inside
plastic surfaces of the handle brackets. Then lower the rear
doorcover
21
.
NOTE: If installed, remove rear side discharge chute
25
and
ensure the rear door cover
21
is fullyup before installing
grass collection bag
22
.
handle away from the handle support
2
until an audible
click is heard, indicating that it is locked into the upper
heightposition.
3. Ensure the main handle
4
locks intoposition
beforeproceeding.
NOTE: When the batteries
26
and safety key
6
are
inserted and the bail handle
8
is pulled, the handle folding
indicator
15
will illuminate if the single touch handle
1
is
not locked intoposition.
4. To retract the main handle
4
to the lower height postion,
press the handle release button
5
and push the main
handle
4
towards the handle support
2
until an audible
click is heard, indicating that it is locked into the lower
height position.
Storage Mode (Fig. G—L)

DANGER: MAKE CERTAIN THE SAFETY KEY IS
REMOVED TO PREVENT ACTUATION BEFORE
REMOVING OR INSTALLINGBATTERIES.

DANGER: Turn unit off and remove safety key and
batterypacks.
1. To retract the main handle
4
, press the handle release
button
5
and push the main handle
4
towards the handle
support
2
until two audible clicks are heard, indicating that
both sides of the handles are locked intoposition. The main
handle
4
must be fully seated against the handle support.
NOTE: The main handle
4
must fully engage the handle
windows
29
. If they are not engaged as shown in Fig. G,
press the main handle
4
towards the handle support
2
until two audible clicks areheard and both sides of handle
windows
29
are closed as shown in Fig.H.
NOTE: Ensure the two storage latches
30
at the back of
the single touch handle
1
tubes pop outward as shown in
Fig. J before lowering the single touch handle
1
into the
stoargeposition.
2. Fold the single touch handle
1
towards the front
wheels
32
into storage position . Listen for two audible
clicks as the two storage latches
30
slide into the
storageslots
31
as shown in Fig. K.
3. Ensure the single touch handle
1
is locked intostorage
position before proceeding.
4. The mower can be stored standing up, with the collection
bag removed, or flat on itswheels as shown in Fig. L.
NOTE: Take care to not pinch, pull or otherwise stress
thecord
28
.
Single Touch Handle Adjustments (Fig. D, E)
The mower is shipped in the storage position. You will need
to adjust the single touch handle
1
to the operating position
beforecontinuing.
Raise the Single Touch Handle (Fig. D)
1. To unlock the single touch handle
1
from the storage
position, squeeze the handle unlock button
3
.
NOTE: The handle unlock button
3
is located on the back
of handle support
2
.
NOTE: The main handle
4
must pop out slightly from both
sides of the single touch handle tubes before lifting the
single touch handle
1
from the storageposition as shown
in Fig. D,.
2. Raise the single touch handle
1
to the locked position.
Listen for an audible click and ensure the single touch
handle
1
is locked intoposition before proceeding.
3. Extend the main handle
4
outward until a set of audible
clicks is heard. The single touch handle
1
is now in the
operation position.
NOTE: Take care to not pinch, pull or otherwise stress
thecord
28
.
Adjusting the Main Handle Height (Fig. F)
The main handle
4
extends to accommodate taller users.
1. To extend the main handle
4
to the lower height position,
press the handle release button
5
and pull the main
handle away from the handle support
2
until an audible
click is heard, indicating that it is locked into the lower
heightposition.
NOTE: The handle release button
5
is located on the
bottom of handle support
2
.
2. To extend the main handle
4
to the upper height position,
press the handle release button
5
and pull the main
ASSEMBLY AND ADJUSTMENTS

DANGER: To reduce the risk of serious personal
injury, turn unit off and remove the safety key and
battery packs before making any adjustments or
removing/installing attachments or accessories. An
accidental start-up can causeinjury.
Intended Use
This lawn mower has been designed for professional lawn
mowingapplications.
DO NOT use under wet conditions or in the presence of
flammable liquids orgases.
This lawn mower is a professional lawn care appliance.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
thistool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
withoutsupervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with thisproduct.