Need help?Do you have a question about the DeWalt XR DCS355 and is the answer not in the manual?
General| Voltage | 18 V |
|---|---|
| Oscillations per Minute | 0-20, 000 OPM |
| Tool-Free Accessory Change | Yes |
| Power Source | Cordless |
| LED Light | Yes |
| Battery Type | Lithium-Ion |
| Oscillation Angle | 1.6 degrees |
Keep work area clean, avoid explosive atmospheres, keep bystanders away.
Match plugs, avoid earthed surfaces, protect from rain/wet, don't abuse cord.
Stay alert, use PPE, prevent unintentional starting, remove keys, don't overreach.
Use correct tool, maintain tools, disconnect power before adjustments.
Recharge with specified charger, use designated packs, keep away from metal.
Have tool serviced by qualified person, never service damaged battery packs.
Observe regulations for sanding paint, use vacuum extractor, handle lead paint carefully.
Identify residual risks like hearing impairment, injury from particles, burns, prolonged use.
Motor designed for one voltage, check ratings, ensure proper mains voltage.
Use approved cable, minimum 1mm², max 30m length.
Plug in charger, insert battery, check charging light indicators.
Understanding charge status indicators like charging, fully charged, hot/cold pack delay.
Charger waits for battery to reach optimal temperature before charging.
Do not charge/use in explosive atmospheres, never force pack into charger.
Do not splash liquids, avoid high temperatures, do not incinerate battery.
Protect terminals, avoid short circuits, no lithium-ion in checked baggage.
Instructions on installing, removing, and checking the fuel gauge of battery packs.
Guides for attaching various accessories like clamps, sanding sheets, cut guides, and adapters.
General usage guidelines, safety warnings during operation, and proper hand positioning.
Explains trigger operation, lock-on button, speed selector, and LED worklight.
How to attach and use the dust extraction adaptor with different accessories.
Tips for workpiece holding, sandpaper use, managing tool overheating, and blade sharpness.
The power tool requires no additional lubrication.
Blow out dust with dry air, use approved eye protection and dust mask. Avoid solvents.
Use only DEWALT recommended accessories for safety and performance.
To Next Page
