DeWalt XR LI-ION DCB115 - Electrical Safety; Mains Plug Replacement (U.K. & Ireland Only); Using an Extension Cable; Important Safety Instructions for All Battery Chargers

30
ENGLISH

WARNING! Read all safety warnings and all instructions. Failure to follow the
warnings and instructions may result in electric shock, fire and/or seriousinjury.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
Electrical Safety
The electric motor has been designed for one voltage only. Always check that the battery
pack voltage corresponds to the voltage on the rating plate. Also make sure that the
voltage of your charger corresponds to that of yourmains.
Your
DeWALT
charger is double insulated in accordance with EN60335; therefore
no earth wire isrequired.
If the supply cord is damaged, it must be replaced by a specially prepared cord available
through the
DeWALT
serviceorganisation.
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the oldplug.
• Connect the brown lead to the live terminal in theplug.
• Connect the blue lead to the neutralterminal.

WARNING: No connection is to be made to the earthterminal.
Follow the fitting instructions supplied with good quality plugs. Recommended fuse: 3A.
Using an Extension Cable
An extension cord should not be used unless absolutely necessary. Use an approved
extension cable suitable for the power input of your charger (see Technical Data). The
minimum conductor size is 1mm
2
; the maximum length is30m.
When using a cable reel, always unwind the cablecompletely.
Important Safety Instructions for All Battery Chargers
SAVE THESE INSTRUCTIONS: This manual contains important safety and operating
instructions for compatible battery chargers (refer to TechnicalData).
• Before using charger, read all instructions and cautionary markings on charger, battery
pack, and product using batterypack.

WARNING: Shock hazard. Do not allow any liquid to get inside charger. Electric shock
mayresult.