2
Press and hold HEAD DOWN button of remote, head actuator moves in, stop when released；
3. FOOT UP
Long press the corresponding button, the foot driver extends, release the driver to stop running
4. FOOT DOWN
Long press the foot down button, the foot driver retracts, release the driver to stop running
5.FLAT
Click the FLAT button and release it, the head and foot drivers run to the lowest position (when the driver
is idle, the vibration motor can be turned off with one button, and the indicator light of the vibration motor can be
turned off), and the action will stop when any button is pressed;
FCC Statement：
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this de
vice may not cause harmful interference, and (2) this device must accept any interference received, including in
terference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s aut
hority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference i
n a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not instal
led and used in accordance with the instructions, may cause harmful interference to radio communications. Howe
ver, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and o
n, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Important Note:
To Next Page
Loading...