12
Guidance and manufacturer’s declaration - electromagnetic immunity for all EQUIPMENT and
SYSTEMS
Guidance and manufacturer’s declaration - electromagnetic immunity
This camera is intended for use in the electromagnetic environment specified below. The
customer or the user of this camera should assure that it is used in such an environment.
Immunity test IEC 60601
test level
Compliance level Electromagnetic
environment – guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2
±6 kV contact
±8 kV air
±2, 4 & 6 kV
contact
±2, 4 & 8 kV air
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should
be at least 30 %.
Electrical fast
transient/burst
IEC 61000-4-4
±2 kV for power
supply lines
±1 kV for input/
output lines
±2 kV for power
supply lines
Not applicable
Mains power quality
should be that of a typical
commercial or hospital
environment.
Surge
IEC 61000-4-5
±1 kV line(s) to
line(s)
±2 kV line(s) to
earth
±0.5 & 1 kV
differential mode
Not applicable
Mains power quality
should be that of a typical
commercial or hospital
environment.
Voltage dips,
short
interruptions and
voltage variations
on power supply
input lines
IEC 61000-4-11
<5 % U
T
(>95 % dip in U
T
)
for 0,5 cycle
40 % U
T
(60 % dip in U
T
)
for 5 cycles
70 % U
T
(30 % dip in U
T
)
for 25 cycles
<5 % U
T
(>95 % dip in U
T
)
for 5 sec
Not applicable
Not applicable
Not applicable
Not applicable
Mains power quality
should be that of a typical
commercial or hospital
environment. If the user of
this camera requires
continued operation
during power mains
interruptions, it is
recommended that this
camera be powered from
an uninterruptible power
supply or a battery.
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
3A/m Not applicable Power frequency magnetic
fields should be at levels
characteristic of a typical
location in a typical
commercial or hospital
environment.
NOTE U
T
is the a.c. mains voltage prior to application of the test level.
DEXcam3-EN.book Page 12 Monday, January 23, 2017 9:27 AM
To Next Page
Loading...