DFRobot FireBeetle ESP32-E - Page 90

Configure Parameters in Arduino Code
//Configure WiFi name and password
char *WIFI_SSID = "WIFI_SSID";//Input WiFi name
char *WIFI_PASSWORD = "WIFI_PASSWORD";//Input WiFi Password
//Configure IFTTT
char *IFTTT_ENVENT = "Your_Event";//Input Event Name
char *IFTTT_KEY = "Your_Key";//Input the key you found in IFTTT
//IFTTT Send Message
char *IFTTT_VALUE_1 = "Value1";
char *IFTTT_VALUE_2 = "Value2";
char *IFTTT_VALUE_3 = "Value3";//Configure the three values in email information
Result
Receive the data from FireBeele-ESP32-E in the Email box.
ifttt.IFTTTBeging(IFTTT_ENVENT,IFTTT_KEY);
int dataSendState = ifttt.IFTTTSend(IFTTT_VALUE_1,IFTTT_VALUE_2,IFTTT_VALUE_3);
Serial.println(dataSendState);//Whether the printing data is sent successfully
}else {
Serial.println("WiFi Disconnected");
}
lastTime = millis();
}
}