INSTALLATION AND MAINTENANCE MANUAL
DUROSITE
LED LINEAR FIXTURE
Document No: 9100-127-2209-99 Rev A
April, 2014
MODELS
(2 foot Versions) (4 foot Versions)
LPM3C4D2P LPM3C4M2P
LPM3C4B2D LPM3C4H2D
These instructions contain important safety information, read and
follow them carefully. Dialight will not accept any responsibility for
injury, damage or loss which may occur due to incorrect installation,
operation or maintenance
1: Introduction
This Linear LED light is designed for illumination of industrial locations. It uses the latest in solid state
lighting technology for long life, low maintenance, and high efficiency.
The unique optical design focuses light downward to where it is needed, giving improved efficiency over
a conventional HID luminaire.
An internal, universal input, power-factor-corrected switch-mode supply allows it to be used from any
nominal 100V-277V, 50/60Hz AC supply without any variation in light output.
Models listed above are SUITABLE FOR WET LOCATIONS in unclassified locations:
Temperature Code: T5 for 2' model, T5 for 4' model
Ambient Temperature Range: -40C to +65C
Note: Save these instructions for future reference.
To Next Page
Need help?
General
