Need help?Do you have a question about the Diamond CC3500 and is the answer not in the manual?
Read and understand instructions before operating saw. Always wear safety approved hearing, eye, head and respiratory protection.
Examine cutting blades before each use. Blade should have no cracks, nicks or flaws. Center hole should be undamaged.
Saw must not be left unattended while the engine is running. Always remember to keep both hands on the handles.
Never operate the saw in any application or job where you are not trained or supervised. Operate only in well ventilated areas.
Instructions for assembling the saw, including handle attachment, battery connection, and oil level checks.
Proper blade selection, mounting, alignment, and water usage for wet sawing are detailed.
Steps to start the saw, including checking oil, neutral position, and warming up the engine.
Guide on how to raise/lower the blade and move the saw using the speed control handle.
Instructions for aligning the blade, setting depth, and beginning the cutting process.
Procedures for raising the blade and stopping the saw after completing a cut.
Instructions for transporting the saw safely, including engaging the drive system and securing it.
Daily and periodic maintenance tasks, including lubrication, oil checks, and filter cleaning.
Table detailing maximum cutting depths for various blade sizes and model capacities.
To Next Page
General